Description
When your excavator's hydraulics start feeling sluggish or your loader bucket moves slower than usual, there's a good chance contaminated hydraulic fluid is the culprit. Clean hydraulic fluid is what keeps your equipment's loader, boom, bucket, and steering systems working smoothly, and this Baldwin filter stands guard against the dirt, water, and metal particles that can turn expensive hydraulic components into costly scrap metal.
What You're Getting
- Quality Baldwin construction with proven filtration media that captures contaminants while maintaining proper flow
- 5 21/32-inch length with 3 11/16-inch outer diameter provides adequate filtration capacity for demanding hydraulic systems
- 1 1/8-16 thread size fits standard hydraulic filter bases without adapters or modifications
- Sturdy housing that handles pressure spikes, temperature swings, and the vibration that comes with construction and agricultural work
- Direct replacement filter that installs quickly and seals properly to prevent bypass
Built for Real Construction and Farm Work
This filter works across Hitachi excavators and Kubota loaders and excavators that spend their days in dusty, demanding conditions. Whether you're digging drainage ditches, moving dirt piles, loading trucks, or running hydraulic attachments, these machines put serious demands on their hydraulic systems with frequent cycling and high operating pressures.
Made to Last
Baldwin has been making filters for decades, and they understand what it takes to handle the contamination loads and pressure demands of working hydraulic systems. The filtration media captures particles and debris before they can damage sensitive pumps, valves, and cylinders, while the robust housing withstands the constant pressure changes and harsh operating conditions your equipment faces every day.
Installation Notes
This is a direct spin-on replacement that installs in minutes. Clean the filter housing thoroughly before installing the new filter to prevent contaminating fresh fluid with debris. Apply a thin coat of clean hydraulic fluid to the gasket, then hand-tighten until the gasket contacts the mounting surface, plus another three-quarters turn.