Description
Whether you're plumbing a hydraulic tank, setting up a spray system, or connecting different pipe sizes anywhere on your operation, you need fittings that won't leak or fail when the pressure's on. This galvanized reducer bushing steps your connection down from 1-1/4 inch to 1 inch, giving you the flexibility to connect equipment with different port sizes without starting over with new pipe.
What You're Getting
- Male threads on the outside (MNPT) screw into a 1-1/4 inch fitting while female threads inside (FNPT) accept a 1 inch pipe or fitting
- Hot-dipped galvanized coating resists rust and corrosion even in wet conditions or chemical exposure
- Heavy-duty construction handles the pressure and vibration that comes with farm equipment
- Standard NPT threads ensure a tight, leak-free seal when properly installed
Built for Real Farm Work
This fitting works great in hydraulic systems, water lines, chemical injection setups, and anywhere you need to transition between pipe sizes. It's commonly used on spray rigs, irrigation systems, hydraulic reservoirs, and fuel transfer setups where different equipment manufacturers use different port sizes.
Made to Last
The galvanized finish means this fitting can handle everything from hydraulic fluid to liquid fertilizer without corroding or failing. It's built to the same standards as the fittings that come on your equipment from the factory, so you know it'll hold up to farm conditions.
Installation Notes
Use pipe thread sealant or Teflon tape on the male threads for the best seal. Don't over-tighten—snug it up until the threads are fully engaged, then add about a half turn more. If you're working with hydraulic systems, make sure to relieve pressure before installing.
This item is a suitable alternative for the following:
108-44252